12/10/2023 0 Comments Corsair harpoon mouse keeps blinkingIn fact they RMA'ed the Harpoon, and when the replacement mouse acted up too, they offered me an Iron Claw instead (kind of 'here's a cup of STFU'). On a sidenote: I had a support case with Corsair for 3 months, and at no point did they suggest anything along those lines. Spot on - I did exactely the same, and the lagging is gone. I found this eliminated all my lag issues with my Harpoon mouse. What I had to do was plug the mouse dongle into the rear of the case as you normally would and I plugged my headset and keyboard dongles into the back of my PC screen. Urgent action needed or else I will give this mouse back and switch to good old logitech. I suspect the dongle and/or mouse firmware. I have practically tried everything I could. Also closing the icue software (completely) doesn't help either. When I switch between USB ports, it works for a while (seconds, minutes at best), then exactly the same tracking problems start as described by and re-installing devices, software as well as the latest AMD chipset drivers did not help. Since it is also not working with Bluetooth, I do not think that we have a frequency interference problem here. The problems started to happen with the latest firmware upgrade (v1.9.85). When I use it with the provided USB cable, I don't have any of those problems.Īt first everything was ok. I cannot use my "wireless" mouse in wireless mode (not with the dongle and not with Bluetooth). I have exactly the same problems and it is utterly frustrating. I then proceeded to play some games and then do some web browsing and did NOT experience the same issues as before. Had the same behavior on all ports across different systems.īut when I plugged the Harpoon in to a USB hub (powered by the same USB port, NOT externally powered) the sensor light remained full and bright the whole time. I used my phone camera to look at the sensor below the mouse when it was directly plugged in to the USB port, and it would have a full, bright light for a few seconds after lifting it up, then it would sort of flicker and fade out until I ran my finger over it. (I've almost never used the mouse in wireless mode, so it has nothing to do with wireless interference).īut considering nobody else has spoken up, I guess I'm alone and the unluckiest gamer of 2019. When I swapped for another one at the store and got the same results, I had to conclude it was a hardware/firmware issue. I'll go ahead and do that.Īnd I was as surprised as you are when I got the second mouse (swapped at the store) I thought I was super unlucky. Guys, if anyone out there has some kind of solution or has experienced the same issues, please speak up because this thingy is driving me nuts but I don't want to give it up. When I plug the Harpoon in to other computers, regardless of USB port or revision (USB 2.0 or 3.0) it always does the same weird tracking drop outs and lags. Then when I grab my Razer Mamba from my other computer and plug it in to the SAME USB port as the Harpoon was using, everything works flawlessly. I've uninstalled iCUE, I've reinstalled iCUE, I've tried older version of iCUE. I've even disabled the "Allow computer to put this device to sleep" setting in Device Manager for EVERY USB device and hub I could find. I have changed the DPI settings, I've changed the lighting settings, I've turned off the lighting settings, I've turned off the sleep settings. I have tried this on 3 Harpoon Wireless mice, with old firmwares, with latest firmwares, with wire, with dongle, with polling rate at 1000, 500, 125, etc. I have not tried BT, but that won't solve anything anyway. Until I pick it up, it will remain stuck regardless of the wild movements I make.ĮDIT: This issue persists whether I use the mouse wirelessly or wired. When this happens, I can still click the buttons - for example, right-clicking brings up the menu, etc - but the pointer will NOT move until I lift the mouse then put it back down. I hate this thing because it randomly (every 30 seconds or so) lags at tracking my movements, and every few minutes it STOPS tracking completely I move the mouse, but the pointer remains completely stuck in place. I love it because it's the perfect mouse for my super weird claw grip, I love the weight, and I love how it works (WHEN it's working). Hi - I registered here because I LOVE this mouse, and I HATE this mouse.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |